|
Feature
|
Purpose
|
|
Full Bridge Power MOSFET
|
Highly efficient and noiseless operation with a wide range of control
|
|
Curtis 1307
|
Allows parameter programming, diagnostics, and testings
|
|
TÜV Compliance
|
Ensures that the product follows standards and requirements
|
|
MultiMode
|
User-select feature offering four operating personalities and the top speed of the vehicle is controlled
|
|
Speed Limit Input
|
Once an external speed limit pot is used, the feature allows linear variable speed limiting
|
|
Enhanced Linear Acceleration and Deceleration
|
This feature has a moderate response to operating smoothly
|
|
Current Limiting
|
Improves braking through increasing regenerative braking current limit
|
|
Load Compensation
|
Enhanced loaded and unloaded regulation of speed
|
|
High Pedal Disable
|
Allows a safe start by monitoring the status of the throttle. If the vehicle is started with an applied throttle, this feature disables it from operating until the throttle is returned to a neutral position
|
|
Key-Off Deceleration
|
Allows smooth stop once it switches off or a fault is detected
|
|
Circuitry for Fault Detection
|
Helps in preventing runaway conditions and monitors components such as the battery, and contactor, among others
|
|
Anti-Forward & Anti-Rollback
|
A safety function that guarantees no unintentional mobilization will occur
|
|
Brake PWM
|
The holding voltage is reducible through the programming of the brake driver
|
|
Reverse Output
|
It moves the piezo beeper in reverse
|
|
Push Switch
|
Allowing free-wheeling of the vehicle by releasing of brakes
|
|
Push-Too-Fast
|
Speed restriction during manual pushing of the vehicle even without power assistance
|
| Power Saving |
Avoids battery drain when not in use
|
|
Protection and Compensation Circuit for Temperature
|
Allows stable current limit and cutback function for during under and over temperature condition
|
|
Over and Undervoltage Protection
|
Protects load from damage
|
|
Polarity Protection
|
Protects the controller by remaining off when the battery wire is reversed due to installation
|
|
Momentary Switch Input
|
Creates a momentary effect to allow end-user input
|
